Tjernlund SS1R SideShot (Discontinued) with UC1 Universal Co Bedienungsanleitung PDF herunterladen (Seite 6)

PLENUM AND VENT HOOD CLEARANCE FROM COMBUSTIBLES

With an inlet flue gas temperature of 575

F or below, the SS1-R has been Listed for the following clearances from combustible materials:

VENT HOOD TERMINATION CLEAOR

TERMINATION CLEARANCES FOR U.S. INSTALLATIONS

Install the SS1-R according to the requirements of the National Fire Protection Association #31, #54 and #211 as follows,

(See Diagram A):

• The exit terminals of mechanical draft systems shall not be less than 7 feet above grade when located adjacent to public walk

ways.

• A venting system shall terminate at least 3 feet above any forced air inlet located within 10 feet.

• The venting system shall terminate at least 4 feet below, 4 feet horizontally from or 1 foot above any door, window or gravity air

inlet into any building.

• The bottom of the vent terminal shall be located at least 12 inches above grade.

• Arrange the exit terminal so that the flue gases are not directed so as to jeopardize people, overheat combustible structures or

enter buildings.

• Not to be less than 2 feet from an adjacent building.

The SS1-R is also Listed to terminate a minimum of 12" below, above or horizontally from a soffit, deck or adjacent sidewall.

Pre-Purge

Post-Purge

Pre-Cycle

Prover Status

Check Deactivated

DIP SWITCH NUMBERING

8 9

PRE-PURGE SETTINGS (SEE “PRE-PURGE”, ON PAGE 4 PRIOR TO SETTING)

12 12 12 12

0 Seconds 5 Seconds 20 Seconds 35 Seconds

POST-PURGE SETTINGS (SEE “POST-PURGE”, ON PAGE 4 PRIOR TO SETTING)

4348657 35678 345678 3 75468

4348657 35678 345678

4 Minutes 8 Minutes 16 Minutes

1 Minute0 Seconds 30 Seconds 2 Minutes

IMPORTANT

Vent Hood and top of Plenum: Zero Clearance

Plenum front and sides: 1/2 inch

Plenum rear: 3 inches

P1 & P2 PRE-CYCLE FAN PROVER STATUS CHECK

The Pre-Cycle Prover Status Check is deactivated from the factory on the SS1-R. Because of the

low set point of the SS1-R Fan Prover (as low as .03" w.c.) cross winds may cause the Fan Prover

to close prior to a call for heat. Activating the Prover Status Check on the SS1-R may cause

nuisance lockouts.

Pre-Cycle

Prover Status

Check Deactivated

1 9

LED 1 AMBER

LED 2 GREEN

LED 3 GREEN

LED 4 RED

LED 5 RED

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Tjernlund SS1R SideShot (Discontinued) with UC1 Universal Co Bedienungsanleitung Seite 6

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ausrüstung Tjernlund SS1R SideShot (Discontinued) with UC1 Universal Co