Tjernlund SS1R SideShot (Discontinued) with UC1 Universal Co Bedienungsanleitung PDF herunterladen (Seite 10)

INSTALLING PLENUM

Depending on building construction, it may be

necessary to notch out a section of the floor joist

to provide proper clearance for the SS1-R

motor, (See Diagram G).

1. Attach Template B to the floor joist that is to

be notched, aligning the sight line noted on

the template with the end or the outside

casing of the vent hood.

2. Cut out notch on line shown on the template.

NOTCH BRACING

It is recommended and local codes may dictate that the joist be reinforced as outlined below. Bracing of the rim joist is not

necessary.

1. Cut two 2 x 4 pieces of wood 28 inches in length.

2. Center both pieces on each side of the floor joist above the notch and drive 8 16D or larger nails into each piece, (See Diag. H).

CONNECTING THE PLENUM TO THE VENT HOOD

NOTES: Cut any nails which are protruding downward from the subfloor that may come in contact with the SS1-R. Place both slip

joint drivers in your pocket before continuing.

Minimum clearances from the Plenum to any combustible materials must be maintained as listed on page 5. Failure to do so can

cause a fire or explosion resulting in property damage, personal injury or death.

Note: Blower - Motor/Wheel assembly can be removed to make Plenum section easier & lighter to install. Refer to Removal

and Replacement of Motor/Wheel Assembly, Page 18.

1. Connect the Plenum to the Vent Hood by aligning both grooves on the bottom of Plenum with both grooves on the bottom of the

Vent Hood. The Plenum is designed to slide into the Vent Hood, (See Diagram I).

2. Gently slide the Plenum into the Vent Hood until the slip joint guides located on each side of the Plenum are in contact with

each other.

3. Slide the slip joint drivers from the bottom upward over the the slip joint guides as far as possible by hand. A hammer may be

used to tap the slip joint drivers to their final position. Start the slip joint drivers on the slip joint guides with the embossed end

facing down. Do not force slip joints past embossing.

DIAGRAM G

IMPORTANT: DO NOT NOTCH ANY

OTHER JOISTS OTHER THAN THOSE

OUTLINED IN THESE INSTRUCTIONS

DIAGRAM H

DIAGRAM I

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Keine Kommentare

Tjernlund SS1R SideShot (Discontinued) with UC1 Universal Co Bedienungsanleitung Seite 10