Copyright © 1998, Tjernlund Products, Inc. All rights reserved. P/N 8504034REV. 11/97OWNER INSTRUCTIONS, DO NOT DESTROYRecognize this symbol as a
ALTERNATIVE THERMOSTAT WIRING FOR SINGLE ZONE INSTALLATIONSSEQUENCE OF OPERATION ON PAGE 7 CHANGES AS FOLLOWS WHEN WIRING WITH SINGLE ZONE THERMOSTAT:
COMBUSTION AIRAdequate combustion air is vital for proper combustion and for safe venting. Likewise, for proper GPAK performance, adequate com-bustio
11SYMPTOM 1: POWER VENTER DOES NOT RUN DURING CALL FOR HEAT Step 1.2 Interlocked directly with gas valve Check for loose connections between appli-anc
MAINTENANCE1. For optimum motor life, oil motor every six months with 2 drops of S.A.E. #20. The oil ports are located on the top of the motor. Magn
Tjernlund Products, Inc. will issue credit to the original distributor or provide a free part to replace one that becomes defective during theone year
VH1-4 VENT HOOD MOUNTING TEMPLATE1. Attach the Vent Hood Mounting Template to the interior of the wall the vent hood will be penetrating.2. Ensure tha
TABLE OF CONTENTSPAGE(S)GPAK DESCRIPTION ...
EQUIVALENT PIPE LENGTH CALCULATION EXAMPLESPECIFICATIONSINSTALLATIONINSTALLATION RESTRICTIONSDo not install the Power Venter on incinerators, condensi
The Power Venter must be installed by a qualified installer in accordance with these instructions and all local codes or in theirabsence in accordance
*SAFETY INSPECTION OF A PREVIOUSLY USED GAS APPLIANCE(Perform prior to GPAK installation)The following procedure is intended as a guide to aid in dete
VENT HOOD INSTALLATION1. Attach the template on page 14 to the interior of the wall the vent hood will be penetrating.2. Verify that wall penetration
DRAFT CONTROL INSTALLATIONWhen installing any GPAK-Series Side Wall Venting System on a fan assisted furnace a barometric draft control must be added.
2. To facilitate installation and reduce vibration we have included 2 mounting brackets, 2 rubber isolaters and 2 rubber grommets. One of the brackets
8
Kommentare zu diesen Handbüchern