Tjernlund VP-2F, VP-3F Airotronics Timer 8504140 Rev A 11/11 Bedienungsanleitung

Rev. A 11/11 Copyright © 2011, Tjernlund Products, Inc. All rights reserved. P/N 8504140NOTE: The VP-2F and VP-3F Water Heater Vent Packages use a Li

VP-2F / VP-3F WATER HEATER VENT PACKAGE LADDER WIRING DIAGRAMCOMBUSTION AIR TESTWARNING:The Linear Limit spillage sensing switch is designed to alert

PERFORMANCE CURVES10VP-2F PERFORMANCE CURVEVP-3F PERFORMANCE CURVE

VP-2F / VP-3F TROUBLESHOOTING GUIDE11Note: For further assistance contactSolutionStep 6SolutionStep 5SolutionStep 4SolutionStep 3Step 2Step 1Symptom 1

12Note: For further assistance contactStep 3.2Step 6Step 3.1Step 5SolutionStep 4SolutionStep 3Step 2Step 1Symptom 2at 1-800-255-4208, 7:30 - 4:30 CST.

MAINTENANCE1. The VP-2F & VP-3F motors are permanently lubricated and do not need to be oiled.2. The owner must semiannually inspect the vent hood

VENT HOOD MOUNTING TEMPLATE FOR VP-2F & VP-3F1. Use scissors to detach template. Verify “Vent Hood Installation Clearances” on page 5 are adhered

Tjernlund Products welcomes your comments and questions. Address all correspondence to: Customer Service, Tjernlund Products Inc., 1601 Ninth Street,

INSTALLER NOTES1. The installer must read and follow these instructions carefully to assure proper installation and operation of the water heater vent

3INSTALLATION RESTRICTIONSThe Power Venter shall not be installed on incinerators, condensing type appliances or solid-fuel burning appliances. The Po

47. Use the 1/4" tubing to connect gas pressure switch fitting to the PRESSURE TAP PORT fitting on the thermostat/gas control valve.8. Conduct a

THERMOCOUPLE JUNCTION ADAPTER INSTALLATIONUnscrew thermocouple from gas valve and screw in Thermocouple Junction Adapter.Screw thermocouple into Th

VENT HOOD INSTALLATION1. Verify that proposed Vent Hood location will conform to “Vent Hood Termination Clearances” on page 5.2. Use scissors to deta

MOUNTING POWER VENTER1. To facilitate installation and reduce vibration, we have included 2 mounting brackets, 2 rubber isolators and 2 rubber grommet

ACTUATING AND SAFETY CONTROL CIRCUIT CONNECTIONS1. If not previously completed, push both leads from the Linear Limit spill switch onto Thermocouple J